Evenflo Triumph User Manual

OWNER’S MANUAL© Evenflo Company, Inc. 200725700172 5/07Triumph Advance™ Child Restraint SystemPara instrucciones en Español, llamar al: 1-800-233-59

Remove locking clip from vehicle seat belt when not used with a child restraint, or the vehicle seat belt will not properly restrain an adult or child

SecureRight™ Quick Connector™LATCH is a system for attaching the child restraint to your vehicle seat. It is to be used in place of your vehicle’s s

21205After the LATCH harness E has been correctly inserted, it will appear as shown above. NOTE: Make sure the adjustment buckle F is on the correct s

Adjust the child restraint to either the Intermediate Recline or the Full Upright Position. 1 Forward-facing Installation Using the Seat BeltAAdju

Using your full weight press down on the child restraint (as shown in step 5) as you tighten the seat belt.Then, hold the lap and shoulder belts toget

SecureRight™ Quick Connector™LATCH is a system for attaching the child restraint to your vehicle seat. It is to be used in place of your vehicle’s s

SecureRight™ Quick Connector™2928Remove two LATCH hooks A, or clips B,from the the base C.1AC2Remove the LATCH harness E from the rear- facing positio

31307Using your full weight push the child restraint firmly into the vehicle seat, while pulling up on the LATCH harness to tighten. The LATCH harness

Securing YourChild3332DE➚➚AAInsert both buckle tongues A into the buckle C. Pull up on the harness strap to check that the buckle tongues are fastened

To adjust the crotch strap, grasp the bottom of the strap A and twist it to align with the length wise slot B. Move to the desired position. Twist th

This child restraint meets all the requirements of Fed-eral Motor Vehicle Safety Standard 213. No restraint can guarantee absolute protection from inj

SecureRight™ Quick Connector™DC➚Removing Child & Seat1To unfasten the chest clip, squeeze the tabs A together and pull apart.Removing Child from t

You will need to remove your seat pad for cleaning.1Removing the Seat PadOpen the access flap and remove the seat pad B from the seat shell. Unbuckle

The optional Infant Head Support E should lie flat against the seat back, as shown. Be sure to cut off the plastic attachment between the head support

4342For a period of 90 days from the original purchase of this Product, Evenflo warrants to the original end user (“Purchaser”) this Product (including

• www.evenflo.com • USA: 1-800-233-5921 8 AM – 5 PM EST • México: 01-800-706-12-00Answers. Advice. Affirmation.™

3WARNING2Location Warnings• According to statistics, children are safer when proper-ly restrained in a rear seating position than in the front seatin

5WARNING4WARNING• DO NOT allow the seat belt release button to touch the child restraint. Accidental contact may cause the seat belt to release. If n

7• Child restraints could be recalled for safety reasons. You must register this restraint to be reached in a recall. Send your name, address, the

1204A I R B A G203010Back View9Locking ClipAir BagDo not place your child restraint by any air bags. Consult your vehicle owner’s manual for airb

1. Secure child restraint to the vehicle seat.• Child restraint is in Position #1 (page 14).• Install with vehicle seat belt (page 14) or LATCH system

1. Secure child restraint to the vehicle seat.• Child restraint is in Position #2 or #3 (page 22).• Install with vehicle seat belt (page 22) or LATCH

ABInfants MUST always ride facing the rear of the vehicle; the back of the child restraint supports and protects the baby and absorbs crash forces. NE